Skip to main content

Vertical Hand injection Machine



1. The cost of the machines is increased depending on their functions and Size .

2. The simplest Injection Moulding machine is a hand injection moulding machine With a very low cost .

3. The simplest mode of injection moulding machine may be considered as hand operated mode, which is an apt equipment to underStand the interaction of major operating parameters.

4. The machine consists of Barrel, Plunger, Band Heaters along with energy regulator, Rack & Pinion system for injecting the material by the plunger, a torpedo and nozzle. 

5. The clamping is done manually on a working table. The machine is fitted on the working table. Heating is set manually . 

6. The capacity of . the machine is available from 0.5 Oz to 2 Oz. Once heating is achieved the production starts manually.

7. The quality of the product is completely depend upon the skill of the operaton .The heating set point is achieved by heat & trial method.

8.Although Temperature controller may be fitted on the machine, but the set point is completely depend on the quantity of product produced by the operator.

9. The cycle time is completely variable and it depends on the competence of the operator.

10. The function of the torpedo is to help the material for proper melting and crate back pressure for help in mixing.


Popular posts from this blog

Breaker Plate & Screen Pack :

Breaker Plate - 1. This is performed metal disk,  with a multitude of small diameter holes. 2. The breaker plate is placed in between the screw and the die assembly. 3. It's principal function is to provide support for the screen pack . 4. The breaker plate helps also to convert the spiral flow of the polymer melts leaving the screw into a linear, axial one. Screen Pack - 1. Screen Pack is usually a multilayered,  nearly symmetrical sandwich of metallic wire screens.  2. It is placed between the screw and the breaker plate,  using the latter for physical support. It's  role is to eliminate the particulate contaminants.  3. The screen pack composition is always based on trade-offs, there is need to eliminate particulates using screens with high mesh,  but at the same time this create flow restriction,  it reduced the throughput, thus low mesh would be preferred.  4. Decision should be made as for as the maximum tolerabl...
Read more

Barrel & Hopper Cooling System (Elements) :

                    : Barrel Cooling : 1. Barrel cooling is needed to prevent overheating that may cause degradation. 2. For small extruders fans that blow air over or around the barrel are used. 3. Other cooling system used include . 4. Cooling channel inside the barrel wall. 5. Find on the barrel or on the heaters to speedup that transfer. 6. A watet-fog spray over barrel. 7. Continuous, controlled vaporization of liquid (water) 8. Copper tubing carrying cold water is sometimes used.               *Hopper Cooling Systems* • Water-cooling is used to cool the hopper throat to prevent bridging and to protect the rubber parts present in the screw support  assembly.
Read more