Skip to main content

Heating & Cooling Elements :

Heating Systems (Element) -
There are three methods of heating extruders:
1. Electric. (Three Type heating)
2. Fluid.(click here)
3. Steam Heating.(click here)
Electric Heating :
(a). Induction Heaters.(click here)
(b). Cast-in Heaters.(click here)
(c). Band Heaters (Two Type Heaters).(click here)
         (i).  Mica Insulated
         (ii). Ceramic Insulated
√ The electric heating is most commonly used due to :
• Accuracy
• Reliability
• Easy to hook up.
                 *Cooling Systems*
 
  1. Barrel Cooling.(click here)
  2. Hopper Cooling.(click here)
  3. Screw Cooling.(click here)

Popular posts from this blog

Breaker Plate & Screen Pack :

Breaker Plate - 1. This is performed metal disk,  with a multitude of small diameter holes. 2. The breaker plate is placed in between the screw and the die assembly. 3. It's principal function is to provide support for the screen pack . 4. The breaker plate helps also to convert the spiral flow of the polymer melts leaving the screw into a linear, axial one. Screen Pack - 1. Screen Pack is usually a multilayered,  nearly symmetrical sandwich of metallic wire screens.  2. It is placed between the screw and the breaker plate,  using the latter for physical support. It's  role is to eliminate the particulate contaminants.  3. The screen pack composition is always based on trade-offs, there is need to eliminate particulates using screens with high mesh,  but at the same time this create flow restriction,  it reduced the throughput, thus low mesh would be preferred.  4. Decision should be made as for as the maximum tolerable size of the particulate contaminan
Read more

Advantage and Disadvantages of Injection Blow Moulding Process

√ Advantages - { injection Blow Moulding } 1. Accurate shaping of the neck. 2. A High level of dimensional accuracy. 3. Mini weight tolerance. 4. The highest quality surface finish. 5. Production absolutely free from waste. 6. Crystal clear containers for pharmaceutical  application. 7. Finished bottle without weld line and scrap. 8. Secondary /finishing operation can be avoided. 9. Multi-cavities can be operated. √ Disadvantages -{ injection Blow Moulding } 1. The preform design generally establish the core rod length & diameter. 2. The process is more expensive than extrusion blow moulding. 3. Compromise between preform wall thickness and blow up ratio. 4. The ratio of the maximum wall thickness to minimum wall thickness across a preform cross-section should be less than 1.5 to prevent weld lines. 5. Preform thickness greater than 6 mm is unstable during blowing since the thick section cannot be properly conditioned. 6. The technique is not suitable
Read more